Guitar Gear Forum

Sweet. Thanks.

I am heading out to run my errands and stuff. Once I settle back in later I will watch a few tutorials and get started with it. Probably set up my Tweed Pro and give it a go. That amp sounds stunning with post FX. This should be hella fun.

Running amps in to a load box and then in to the Captor will blow your mind.

Ya can't go wrong with Eventide!!!
Clips sound really, Really, REALLY GOOD!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

So I got my Tweed hooked up and gave the H90 a quick run through. I was playing through my PDI-03 into my DAW/monitors, so I don't have the benefit of hearing through a cabinet yet. Just scrolling through the presets I found some cool stuff. But I wasn't falling in love with too much. Then I just hit record and started fucking around while I scrolled through the presets. Not really paying attention or focusing on my playing. Just goofing off to the weird sounds. After about 8 minutes, I hit stop and sat down. Pressed play and now what I am hearing on playback is mind blowing. The effects are so clear and pristine. I definitely need to learn the pedal. But damn it sounds so good.

There's a steep learning curve. I had Shea to help walk me through the basics and provide some presets which helped immensely. Also, there are a million tutorials on youtube for whatever you're trying to accomplish.

How are you currently running it? Are you mic'ing the amp in to the interface then bussing out for the H90?

derp sorry I didn't know what the PDI-03 was.

Make sure all the inputs/outputs are set to line level as well when you're running it that way.

Vladimir Putin wrote: ↑Fri Apr 05, 2024 9:30 pm There's a steep learning curve. I had Shea to help walk me through the basics and provide some presets which helped immensely. Also, there are a million tutorials on youtube for whatever you're trying to accomplish.

How are you currently running it? Are you mic'ing the amp in to the interface then bussing out for the H90?

Amp>Palmer PDI-03>UA Twinfinity>H90>RME Babyface>Reaper. It was the quickest and dirtiest way to run through it. I am going to sit down after dinner and start learning my way around it. I am also going to pull the Twinfinity out of the chain. I don't want to add any un-necessary gain to the signal until I figure things out.

I was about to say, run the PDI straight in to the H90 then run that in to the 1/4" inputs on the side of the interface. No need to boost the chain with the mic preamps if you're using IRs in your DAW