I've been curious about this pedal because I like the idea of having am overdrive with a built-in gate. But every clip I found of it were modern metal clips, which don't give me much of an idea of how it would work for me.
Does anyone here use this pedal as a lead boost in a rock context?
It seem like it's based on the TS circuit, so in theory, it should work. What do guys think?
Horizon Precision Drive
Re: Horizon Precision Drive
I know it had a lot of attention at one point but seemed like a djent thing... if anything I am turned off by the modern-ness of it
Re: Horizon Precision Drive
It is an 808 with a few component values changed (most notably lower minimum gain and lower value tone pot) and a bunch of caps on a switch to dial in the lows. I assume the gate tracks the clean guitar signal and mutes the OD output. That's how I used to run an OD808 and NS2 using the S+R jacks. That worked good compared to the old Decimator with no loop.
I'd get the $50 Demon FX clone.
I'd get the $50 Demon FX clone.
- Guitarbilly
- Site Admin
- Posts: 1363
- Joined: Wed Jan 24, 2024 7:08 am
Re: Horizon Precision Drive
Yeah that's what I thought. If it's an 808 circuit, it should work well with the Marshall.JSutter wrote: ↑Thu Jul 18, 2024 3:52 pm It is an 808 with a few component values changed (most notably lower minimum gain and lower value tone pot) and a bunch of caps on a switch to dial in the lows. I assume the gate tracks the clean guitar signal and mutes the OD output. That's how I used to run an OD808 and NS2 using the S+R jacks. That worked good compared to the old Decimator with no loop.
I'd get the $50 Demon FX clone.
I didn't know there was a $50 clone I'll look into it now.
-
- Posts: 126
- Joined: Thu Jan 25, 2024 6:18 pm
Re: Horizon Precision Drive
I didn't like the Precision Drive that I had. Sounded too modern or something for me. This was a few years ago when I was blowing through every boost/OD I could get my hands on looking for something better than a SD1, TS9, or original Koko. Those three are still here and will be staying. No gas for OD's for a about a year now.
- Guitarbilly
- Site Admin
- Posts: 1363
- Joined: Wed Jan 24, 2024 7:08 am
Re: Horizon Precision Drive
Yeah I've been using the SD-1 or a Way Huge Green Rhino and they sound great but I've been curious about the Precision Drive. It's hard to tell from the djent clips though.
I think I'll get the $50 copy and give it a shot so its no big dealif I end up not liking it
I think I'll get the $50 copy and give it a shot so its no big dealif I end up not liking it
Re: Horizon Precision Drive
If you want the real deal, I’ll sell mine! Hah.
I think it’ll work for you. The attack switch gives plenty of play. It can actually get really fat on the “lowest” setting. And then basically get into standard 808 style sound and then obviously the higher settings are where the djent or downtuned players might try and go. I like it, just don’t use it anymore
I think it’ll work for you. The attack switch gives plenty of play. It can actually get really fat on the “lowest” setting. And then basically get into standard 808 style sound and then obviously the higher settings are where the djent or downtuned players might try and go. I like it, just don’t use it anymore
- Guitarbilly
- Site Admin
- Posts: 1363
- Joined: Wed Jan 24, 2024 7:08 am
Re: Horizon Precision Drive
I might take you up on it. I ordered the $50 Amazon clone if I like it well enough I'll send it back to Amazon and buy yours, since if I'm going to put it on my boars, I want the real deal just for peace of mind. I'm not gigging with no Amazon pedal.Endtime wrote: ↑Thu Jul 18, 2024 6:15 pm If you want the real deal, I’ll sell mine! Hah.
I think it’ll work for you. The attack switch gives plenty of play. It can actually get really fat on the “lowest” setting. And then basically get into standard 808 style sound and then obviously the higher settings are where the djent or downtuned players might try and go. I like it, just don’t use it anymore
- Guitarbilly
- Site Admin
- Posts: 1363
- Joined: Wed Jan 24, 2024 7:08 am
Re: Horizon Precision Drive
I got the DemonFX clone on Saturday, right before my show. Decided to be bold and mounted on my gig board and dialed the pedal in 5 minutes during soundcheck. The pedal sounded good overall. The gate is awesome. But I don't think it will be replacing my SD-1 or my Green Rhino, since the Precision sounds brighter and thinner than both of them. I think it would be a great boost for a Recto or a Bogner or other amps with a thicker, darker tone. With Marshalls, it's a bit too bright. Still, I will be keeping it as another boost option.
Re: Horizon Precision Drive
Hmm. And it’s not because I want to sell mine. But within its settings, especially in the first “2” clicks on the attack settings of the precision drive I def would not consider that brighter than an SD1. Especially the first one. I find that far too fat tbh. But I have seen this pedal mentioned as an accurate copy of the Precision. But overall the SD1 is brighter and more aggressive within the first 2 attack settings in my experience